nisus.com

I have a 17 page document with 21 sections -- after getting this far, I realize that I set the top and bottom margins too wide. When I change the margins at the top, it only affects the first page. When I change the margins on the second page, only that page is affected. Do I need to go into each section and change the top and bottom margins 21 times, or is there some way I can change the margins for the entire document all at once?

By the way, I do NOT have the box checked in the Sections palette that says "Different this section."

I was going to suggest that you select the whole document and use the margins palette, but apparently that does not work on multiple sections at once. I'll see that this is fixed in time for the next beta of 2.6, thanks for alerting us to the issue.